Certified Wireless Network Administrator CWNA Certification CWNA-108 Practice Test

Regina2021-07-19T03:08:41+00:00

By Regina CWNA, CWNP, Free Questions Online CWNA-108, CWNA-108 practice test

Checking CWNA-108 free demo exam questions is the key step to verify the high-quality of Certified Wireless Network Administrator CWNA Certification CWNA-108 Practice Test. Certified Wireless Network Administrator (CWNA) certification is the base certification for Enterprise Wi-Fi within the CWNP family of certifications and a springboard toward earning your security, design, analysis and network expert certifications. The real and original CWNA-108 practice test are based on the CWNA exam objectives, which are great to ensure that you can pass CWNA exam in the first attempt.

Certified Wireless Network Administrator CWNA-108 Free Demo Exam Questions Online

Page 1 of 2

1. An RF signal sometimes bends as it passes through some material other than free space.

What is the term that describes this behavior?

Refraction

Warping

Scattering

Reflection

2. What can an impedance mismatch in the RF cables and connectors cause?

Increased range of the RF signal

Fewer MCS values in the MCS table

Increased amplitude of the RF signal

Excessive VSWR

3. What factor does not influence the distance at which an RF signal can be effectively received?

Receiving station’s radio sensitivity

Receiving station’s output power

Transmitting station’s output power

Free Space Path Loss

4. A WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB loss.

If the cable is connected to an antenna with 9dBi gain, what is the EIRP at the antenna element?

26 dBm

13 dBm

23 dBm

10 dBm

5. In a long-distance RF link, what statement about Fade Margin is true?

A Fade Margin is unnecessary on a long-distance RF link if more than 80% of the first Fresnel zone is clear of obstructions.

The Fade Margin is a measurement of signal loss through free space and is a function of frequency and distance.

Fade Margin is an additional pad of signal strength designed into the RF system to compensate for unpredictable signal fading.

The Fade Margin of a long-distance radio link should be equivalent to the receiver’s low noise filter gain.

6. What wireless networking term describes the increase of RF energy in an intentional direction with the use of an antenna?

Directed Radiation

Beam Digression

Passive Gain

Active Amplification

7. Which directional antenna types are commonly used by indoor Wi-Fi devices in a MIMO multiple spatial stream implementation?

Dipole and yagi

Grid and sector

Patch and panel

Dish and grid

8. What statement about the beamwidth of an RF antenna is true?

Horizontal and vertical beamwidth are calculated at the points where the main lobe decreases power by 3 d

The beamwidth patterns on an antenna polar chart indicate the point at which the RF signal stops propagating.

When antenna gain is lower, the beamwidth is also lower in both the horizontal and vertical dimensions.

Vertical beamwidth is displayed (in degrees) on the antenna’s Azimuth chart.

9. Which one of the following is not a factor considered when calculating the Link Budget for an outdoor point-to-point WLAN bridge link?

Operating frequency

MU-MIMO capabilities of the bridges

Receive antenna gain

Transmit power

10. What best describes WPA2 in relation to 802.11 wireless networks?

WPA2 is the standard that defines security for WLANs.

WPA2 is a certification created by the Wi-Fi Alliance that validates devices correctly implement CCMP/AE

WPA2 is the second version of WPA and it enhances security through the use of TKIP instead of WE

WPA2 is specified in the 802.11 standard as implementing CCMP/AE

Page 2 of 2

11. An IEEE 802.11 amendment is in the daft state.

What impact does this draft amendment have on the 802.11 standard?

Devices will be released based on the draft amendment and the draft amendment features are part of the standard.

No impact: Until an amendment is ratified, it does not become part of the standard.

No impact: Draft amendments do not become part of the standard until a working group is formed.

The standard is changed to reflect the new capabilities as soon as an amendment enters the draft stage.

12. You are implementing a VHT-capable AP.

Which one of the following channels is available in the 802.112016 standard that was not available before the ratification of 802.11 ac?

161

153

144

13. What statement is true concerning the use of Orthogonal Frequency Division Multiplexing (OFDM) modulation method in IEEE 802.11 WLANs?

OFDM implements BPSK modulation to allow for data rates up to 7 Gbps.

OFDM was first introduced in 802.11a and is used by the ERP, HT and VHT PHYs as well.

OFDM modulation is used only in 5 GHz 802.11 transmissions.

OFDM was used by Frequency Hopping Spread Spectrum (FHSS) PHY devices.

14. Which IEEE 802.11 physical layer (PHY) specification includes support for and compatibility with both ERP and HR/DSSS?

DSSS (802.11-Prime)

OFDM (802.11a)

HT (802.11n)

VHT (802.11ac)

15. An 802.11-based network uses an AP and has several connecting clients. The clients include iPhones, iPads, laptops and one desktop.

What WLAN use case is represented?

Ad-hoc

WPAN

BSS

IBSS

Welcome To Choose Required IT Certification Exams Online

Certified Wireless Network Administrator CWNA Certification CWNA-108 Practice Test

Certified Wireless Network Administrator CWNA-108 Free Demo Exam Questions Online

Author