Get Success In Cisco CCNP Data Center 300-620 DCACI Exam With 300-620 Study Guide

Regina2021-10-06T02:31:50+00:00

By Regina CCNP Data Center, Cisco, Free Questions Online 300-620, 300-620 DCACI Exam, 300-620 free questions, 300-620 study guide

To look for online resource to prepare for 300-620 Implementing Cisco Application Centric Infrastructure (DCACI) exam well, you can choose ITExamShop 300-620 study guide to get success in Cisco CCNP Data Center 300-620 DCACI exam. The excellent Cisco 300-620 study guide offered by the top and experienced team are getting reviewed, the great team verified and can be sure that all the questions with the actual answers are valid for success. Therefore receiving a total undergo of the CCNP Data Center 300-620 DCACI study guide will make it straightforward for you to clear all your doubts. Just choose ITExamShop 300-620 study guide in pdf format to do the best preparation.

CCNP Data Center 300-620 DCACI Free Questions As the Demo Are Listed Below For Testing

Page 1 of 2

1. What represents the unique identifier of an ACI object?

universal resource identifier (URI)

application programming interface

management information tree

distinguished name

2. A customer migrates a legacy environment to Cisco ACI. A Layer 2 trunk is configured to interconnect the two environments. The customer also builds ACI fabric in an application-centric mode.

Which feature should be enabled in the bridge domain to reduce instability during the migration?

Set Multi-Destination Flooding to Flood in B

Enable Flood in Encapsulation.

Set Multi-Destination Flooding to Flood in Encapsulation.

Disable Endpoint Dataplane Learning

3. An engineer needs to deploy a leaf access port policy group in ACI Fabric to support the following requirements:

• Control the amount of application data flowing into the system

• Allow the newly connected device to auto-negotiate link speed with the leaf switch

Which two ACI policies must be configured to achieve these requirements? (Choose two.)

L2 interface policy

link level policy

slow drain policy

ingress control plane policing policy

ingress data plane policing policy

4. When the subnet is configured on a bridge domain, on which physical devices is the gateway IP address configured?

all leaf switches and all spine nodes

only spine switches where the bridge domain of the tenant is present

only leaf switches where the bridge domain of the tenant is present

all border leaf nodes where the bridge domain of the tenant is present

5. What must be configured to allow SNMP traffic on the APIC controller?

out-of-band management interface

contract under tenant mgmt

SNMP relay policy

out-of-band bridge domain

6. An engineer wants to monitor all configuration changes, threshold crossing, and link-state transitions in a Cisco ACI fabric.

Which action must be taken to receive the required messages?

Add Faults and Events to the monitor policy.

Add Session Logs and Audit Logs to the monitor policy.

Include Audit Logs and Events in the Syslog source policy.

Include Events and Session Logs in the Syslog source policy.

7. An engineer configures a Multi-Pod system with the default getaway residing outside of the ACI fabric for a bridge domain.

Which setting should be configured to support this requirement?

disable Limit IP Learning to Subnet

disable IP Data-plane Learning

disable Unicast Routing

disable Advertise Host Routes

8. DRAG DROP

Refer to the exhibit.

A Cisco ACI fabric is newly deployed, and the security team requires more visibility of all inter-EPG traffic flows. All traffic in a VRF must be forwarded to an existing firewall pair. During failover, the standby firewall must continue to use the same IP and MAC as the primary firewall.

Drag and drop the steps from the left Into the Implementation order on the right to configure the service graph that meets the requirements. (Not all steps are used.)

9. What happens to the traffic flow when the Cisco ACI fabric has a stale endpoint entry for the destination endpoint?

The leaf switch does not learn the source endpoint through data plane learning.

The leaf switch drops the traffic that is destined to the endpoint.

The leaf switch floods the traffic to the endpoint throughout the fabric.

The leaf switch sends the traffic to the wrong destination leaf.

10. Regarding the MTU value of MP-BGP EVPN control plane packets in Cisco ACI, which statement about communication between spine nodes in different sites is true?

By default, spine nodes generate 9000-bytes packets to exchange endpoints routing information. As a result, the Inter-Site network should be able to carry 9000-bytes packets.

By default, spine nodes generate 1500-bytes packets to exchange endpoints routing information. As a result, the Inter-Site network should be able to carry 1800-bytes packets.

By default, spine nodes generate 1500-bytes packets to exchange endpoints routing information. As a result, the Inter-Site network should be able to carry 1500-bytes packets.

By default, spine nodes generate 9000-bytes packets to exchange endpoints routing information. As a result, the Inter-Site network should be able to carry 9100-bytes packets.

Page 2 of 2

11. DRAG DROP

An engineer must configure VMM domain integration on a Cisco UCS B-Series server that is connected to a Cisco ACI fabric. Drag and drop the products used to create VMM domain from the bottom into the sequence in which they should be implemented at the top. Products are used more than once.

12. DRAG DROP

Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.

13. A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected.

Which two requirements must be considered in this design? (Choose two.)

ACI underlay protocols, i.e. COOP, IS-IS and MP-BGP, spans across pods. Create QoS policies to make sure those protocols have higher priority.

A single APIC Cluster is required in a Multi-Pod design. It is important to place the APIC Controllers in different locations in order to maximize redundancy and reliability.

ACI Multi-Pod requires an IP Network supporting PIM-Bidir.

ACI Multi-Pod does not support Firewall Clusters across Pods. Firewall Clusters should always be local.

Multi-Pod requires multiple APIC Controller Clusters, one per pod. Make sure those clusters can communicate to each other through a highly available connection.

14. Which type of policy configures the suppression of faults that are generated from a port being down?

fault lifecycle assignment

event lifecycle assignment

fault severity assignment

event severity assignment

Welcome To Choose Required IT Certification Exams Online

Get Success In Cisco CCNP Data Center 300-620 DCACI Exam With 300-620 Study Guide

CCNP Data Center 300-620 DCACI Free Questions As the Demo Are Listed Below For Testing

Author