Updated 300-430 Exam Questions V16.02: Pass Implementing Cisco Enterprise Wireless Networks (ENWLSI) Exam Successfully

Regina2023-03-02T03:53:06+00:00

By Regina CCNP Enterprise, Cisco, Free Questions Online 300-430, 300-430 exam questions, 300-430 free demo, 300-430 study guide

Are you looking to pass the 300-430 Implementing Cisco Enterprise Wireless Networks (ENWLSI) exam with flying colors? Then choose the most updated 300-430 exam questions V16.02 of ITExamShop. This comprehensive exam study guide contains all the information you need to pass the Cisco ENWLSI exam with ease. You’ll learn new strategies and techniques to make the most of your study time and maximize your chances of success. With these updated 300-430 exam questions and answers, you can rest assured that you’ll have everything you need to ace the Cisco 300-430 ENWLSI exam. So don’t wait any longer, start preparing today and achieve your goals with ease!

Choose to check the free demo of updated 300-430 exam questions V16.02:

Page 1 of 3

1. What is the Cisco recommended configuration for a Cisco switch port connected to an AP in local mode for optimal voice over WLAN performance with an 8821 wireless phone?

switchport encapsulation dot1q switchport mode trunk mls qos trust device cisco-phone

switchport mode access mls qos trust device cisco-phone

switchport mode access mls qos trust cos

switchport mode access mls qos trust dscp

2. A network engineer has been hired to perform a new MSE implementation on an existing network. The MSE must be installed in a different network than the Cisco WLC.

Which configuration allows the devices to communicate over NMSP?

Allow UDP/16113 port on the central switch.

Allow TCP/16113 port on the firewall.

Allow UDP/16666 port on the VPN router.

Allow TCP/16666 port on the router.

3. An engineer needs to provision certificates on a Cisco Catalyst 9800 Series Wireless Controller. The customer uses a third-party CA server.

Which protocol must be used between the controller and CA server to request and install certificates?

SCEP

TLS

LDAP

SSL

4. The Cisco Hyperlocation detection threshold is currently set to -50 dBm. After reviewing the wireless user location, discrepancies have been noticed.To improve the Cisco Hyperlocation accuracy, an engineer attempts to change the detection threshold to -100 dBm. However, the Cisco Catalyst 9800 Series Wireless Controller does not allow this change to be applied.

What actions should be taken to resolve this issue?

Disable Cisco Hyperlocation, change the Cisco Hyperlocation detection threshold, and then enable it.

Create a new profile on Cisco CMX with the new Cisco Hyperlocation detection range, and apply it on the WLA

Place the APs to monitor mode, shutdown the radios, and then change the Cisco Hyperlocation detection threshold.

Shutdown all radios on the controller, change the Cisco Hyperlocation detection range, and enable the radios again.

5. Refer to the exhibit.

An engineer needs to manage non-802.11 interference.

What is observed in the output on PI?

At least one strong interferer is impacting connectivity at this site.

Several light interferers are collectively impacting connectivity at this site.

The three individual clusters shown indicate poor AP placement.

RF at this site is unable to provide adequate wireless performance.

6. A corporation has recently implemented a BYOD policy at their HQ.

Which two risks should the security director be concerned about? (Choose two.)

network analyzers

malware

lost and stolen devices

keyloggers

unauthorized users

7. Which statement about the VideoStream/Multicast Direct feature is true?

IP multicast traffic is reliable over WLAN by default as defined by the IEEE 802.11 wireless multicast delivery mechanism.

Each VideoStream client acknowledges receiving a video IP multicast stream.

It converts the unicast frame to a multicast frame over the air.

It makes the delivery of the IP multicast stream less reliable over the air, but reliable over Ethernet.

8. Where is Cisco Hyperlocation enabled on a Cisco Catalyst 9800 Series Wireless Controller web interface?

Policy Profile

AP Join Profile

Flex Profile

RF Profile

9. When using a Cisco Catalyst 9800 Series Wireless Controller, which statement about AutoQoS is true?

It has a set of predefined profiles that you cannot modify further

It matches traffic and assigns each matched packet to QoS groups

It automates deployment of wired QoS and makes wireless QoS implementation easier

It allows the output policy map to put specific QoS queues into specific subgroups

10. An engineer configures a deployment to support:

✑ Cisco CMX

✑ licenses for at least 3000 APs

✑ 6000 wIPS licenses

The Cisco vMSE appliance must be sized for this deployment.

Which Cisco vMSE Release 8 option must the engineer deploy?

Large vMSE

Low-End vMSE

Standard vMSE

High-End vMSE

Page 2 of 3

11. An engineer has been hired to implement a way for users to stream video content without having issues on the wireless network. To accomplish this goal, the engineer must set up a reliable way for a Media Stream to work between Cisco FlexConnect APs.

Which feature must be enabled toguarantee delivery?

Unicast Direct

IGMP Direct

Multicast Direct

Multicast-to-Unicast Direct

12. Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

RF Profile

Flex Profile

Policy Profile

AP Join Profile

13. A company is collecting the requirements for an on-premises event. During the event, a wireless client connected to a dedicated WLAN will run a video application that will need on average 391595179 bits per second to function properly.

What is the QoS marking that needs to be applied to that WLAN?

Platinum

Gold

Silver

Bronze

14. A wireless network has been implemented to enable multicast video to be streamed reliably over the wireless link to the wireless users. After a clientreports that the video is unable to stream, the administrator determines that the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network.

Which two actions must be applied? (Choose two.)

Turn off IGMP snooping for all the configured WLANs on the controller.

Implement video-stream for the multicast video on the controller.

Allow multicast-direct to work correctly and multicast-direct to be enabled globally.

Change the WLAN QoS value to Bronze for the WLAN that multicast will be enabled.

Allow RTSP to stream the video due to wireless multicast not using acknowledgements.

15. A corporation is spread across different countries and uses MPLS to connect the offices. The senior management wants to utilize the wireless network for all the employees. To ensure strong connectivity and minimize delays, an engineer needs to control the amount of traffic that is traversing between the APs and the central WLC.

Which configuration should be used to accomplish this goal?

FlexConnect mode with central switching enabled

FlexConnect mode with central authentication

FlexConnect mode with OfficeExtend enabled

FlexConnect mode with local authentication

16. Which two statements about the requirements for a Cisco Hyperlocation deployment are true? (Choose two.)

After enabling Cisco Hyperlocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.

NTP can be configured, but that is not recommended.

The Cisco Hyperlocation feature must be enabled on the wireless LAN controller and Cisco CM

The Cisco Hyperlocation feature must be enabled only on the wireless LAN controller.

If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyperlocation deployments.

17. An engineer completed the basic installation for two Cisco CMX servers and is in the process of configuring high availability, but it fails.

Which two statements about the root of the issue are true? (Choose two.)

The Cisco CMX instances are installed in the same subnet.

The types of the primary and secondary Cisco CMX installations differ.

The delay between the primary and secondary instance is 200 ms.

The sizes of the primary and secondary Cisco CMX installations differ.

Both Cisco CMX installations are virtual.

18. An engineer is responsible for a wireless network for an enterprise. The enterprise has distributed offices around the globe, and all APs are configured in FlexConnect mode. The network must be configured to support 802.11r and CCKM.

What needs to be implemented to accomplish this goal?

Enable VLAN-based central switching.

Enable FlexConnect local authentication.

Enable FlexConnect local switching.

Create FlexConnect groups.

19. When configuring a Cisco WLC, which CLI command adds a VLAN with VLAN ID of 30 to a FlexConnect group named BranchA-FCG?

config flexconnect BranchA-FCG vlan 30 add

config flexconnect BranchA-FCG vlan add 30

config flexconnect group BranchA-FCG vlan 30 add

config flexconnect group BranchA-FCG vlan add 30

20. A network engineer needs to configure multicast in the network. The implementation will use multiple multicast groups and PIM routers.

Which address provides automatic discovery of the best RP for each multicast group?

224.0.0.13

224.0.0.14

224.0.1.39

224.0.1.40

Page 3 of 3

21. An engineer has implemented advanced location services for a retail wireless deployment. The marketing department wants to collect user demographic information in exchange for guest WLAN access and to have a customized portal per location hosted by the provider.

Which social connector must be tied into Cisco CMX to provide this service?

Gmail

Google+

Facebook

MySpace

22. Refer to the exhibit.

Which COS to DSCP map must be modified to ensure that voice traffic is tagged correctly as it traverses the network?

COS of 6 to DSCP 46

COS of 3 to DSCP 26

COS of 7 to DSCP 48

COS of 5 to DSCP 46

23. An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address.

Which command should be used to reconcile this?

config flexconnect office-extend nat-ip-only disable

config network ap-discovery nap-ip-only enable

config flexconnect office-extend nat-ip-only enable

config network ap-discovery nat-ip-only disable

24. What are two considerations when deploying a Cisco Hyperlocation? (Choose two.)

NTP configuration is available, but not recommended.

The Cisco Hyperlocation feature must be enabled only on the wireless LAN controller.

After enabling Cisco Hyperlocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.

The Cisco Hyperlocation feature must be enabled on the wireless LAN controller and Cisco CM

If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyperlocation deployments.

25. An engineer must track guest traffic flow using the WLAN infrastructure.

Which Cisco CMX feature must be configured and used to accomplish this tracking?

analytics

connect and engage

presence

detect and locate

26. Which two protocols are used to communicate between the Cisco MSE and the Cisco Prime Infrastructure network management software? (Choose two.)

HTTPS

Telnet

SOAP

SSH

NMSP

27. An engineer is managing a wireless network for a shopping center. The network includes a Cisco WLC, a Cisco MSE, and a Cisco Prime Infrastructure.

What is required to use Cisco CMX Location Analytics?

Enable tracking parameters in Cisco MS

Enable Context Aware and CMX Browser Engage.

Install Cisco Prime Infrastructure with floor maps.

Set history parameters in Cisco MS

28. Which two steps are needed to complete integration of the MSE to Cisco Prime Infrastructure to track the location of clients/rogues on maps? (Choose two.)

Synchronize access points with the MS

Add the MSE to Cisco Prime Infrastructure using the CLI credentials.

Add the MSE to Cisco Prime Infrastructure using the Cisco Prime Infrastructure communication credentials.

Apply a valid license for Wireless Intrusion Prevention System.

Apply a valid license for location tracking.

Welcome To Choose Required IT Certification Exams Online

Updated 300-430 Exam Questions V16.02: Pass Implementing Cisco Enterprise Wireless Networks (ENWLSI) Exam Successfully

Choose to check the free demo of updated 300-430 exam questions V16.02:

Author