Valid 300-410 Exam Questions [2022] - Great Preparation Tool For Passing Cisco CCNP Enterprise ENARSI Exam

Valid 300-410 Exam Questions [2022] – Great Preparation Tool For Passing Cisco CCNP Enterprise ENARSI Exam

Regina2022-01-13T03:59:18+00:00

By Regina CCNP Enterprise, Cisco, Free Questions Online 300-410, 300-410 ENARSI, 300-410 exam questions, 300-410 free questions, 300-410 preparation tool

300-410 exam questions have been updated by ITExamShop with 273 practice exam questions and answers, which have been verified by the successful customers who have passed Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) certification exam. Valid Cisco CCNP Enterprise ENARSI 300-410 exam questions of ITExamShop are extremely logical and you can get the maximum info by means of the actual exam questions and answers. Your skills of preparation can be enhanced in the event you take your right time to prepare for the actual 300-410 Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) exam with the valid 300-410 exam questions.

Reading Cisco 300-410 Free Questions Is Recommended To Check 300-410 Exam Questions

Page 1 of 3

1. Which two methods use IPsec to provide secure connectivity from the branch office to the headquarters office? (Choose two.)

DMVPN

MPLS VPN

Virtual Tunnel Interface (VTI)

SSL VPN

PPPoE

2. Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

multi-paths eibgp 2

maximum-paths 2

maximum-paths ibgp 2

multi-paths 2

3. Refer to the exhibit.

In which circumstance does the BGP neighbor remain in the idle condition?

if prefixes are not received from the BGP peer

if prefixes reach the maximum limit

if a prefix list is applied on the inbound direction

if prefixes exceed the maximum limit

4. R2 has a locally originated prefix 192.168.130.0/24 and has these configurations:

What is the result when the route-map OUT command is applied toward an eBGP neighbor R1 (1.1.1.1) by using the neighbor 1.1.1.1 route-map OUT out command?

R1 sees 192.168.130.0/24 as two AS hops away instead of one AS hop away.

R1 does not accept any routes other than 192.168.130.0/24

R1 does not forward traffic that is destined for 192.168.30.0/24

Network 192.168.130.0/24 is not allowed in the R1 table

5. Refer to the exhibit.

Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?

A)

Option A

Option B

Option C

Option D

6. Refer to the exhibit.

Which control plan policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is higher rate?

policy-map SHAPE_BGP

policy-map LIMIT_BGP

policy-map POLICE_BGP

policy-map COPP

7. Refer to the exhibit.

What does the imp-null tag represent in the MPLS VPN cloud?

Pop the label

Impose the label

Include the EXP bit

Exclude the EXP bit

8. Refer to the exhibit.

Network operations cannot read or write any configuration on the device with this configuration from the operations subnet.

Which two configurations fix the issue? (Choose two.)

Configure SNMP rw permission in addition to community ciscotest.

Modify access list 1 and allow operations subnet in the access list.

Modify access list 1 and allow SNMP in the access list.

Configure SNMP rw permission in addition to version 1.

Configure SNMP rw permission in addition to community ciscotest 1.

9. Refer to the exhibit.

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1.

Which action can the engineer take to solve the issue so that all the PCs are reachable?

Set the administrative distance 100 under the RIP process on R2.

Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGR

Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGR

Redistribute the directly connected interfaces on R2.

10. Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

Option A

Option B

Option C

Option D

Page 2 of 3

11. 1.Refer to the exhibit.

Users in the branch network of 2001:db8:0:4::/64 report that they cannot access the Internet.

Which command is issued in IPv6 router EIGRP 100 configuration mode to solve this issue?

Issue the eigrp stub command on R1.

Issue the no eigrp stub command on R1.

Issue the eigrp stub command on R2.

Issue the no eigrp stub command on R2.

12. Refer to the exhibit.

Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?

policy-map SHAPE_BGP

policy-map LIMIT_BGP

policy-map POLICE_BGP

policy-map COPP

13. Refer to the exhibit.

Which statement about R1 is true?

OSPF redistributes RIP routes only if they have a tag of one.

RIP learned routes are distributed to OSPF with a tag value of one.

R1 adds one to the metric for RIP learned routes before redistributing to OSP

RIP routes are redistributed to OSPF without any changes.

14. Refer to the exhibit.

After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing.

Which two actions resolve the issue? (Choose two.)

Change the mode from mode tunnel to mode transport on R3.

Remove the crypto isakmp key cisco address 10.1.1.1 on R2 and R3.

Configure the crypto isakmp key cisco address 192.1.1.1 on R2 and R3.

Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.

Change the mode from mode transport to mode tunnel on R2.

15. Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?

nonbroadcast multiaccess

packet switching

policy-based routing

forwarding information base

16. An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install.

Which command must the engineer run to correct the configuration?

sudo maglev-config update

sudo maglev install config update

sudo maglev reinstall

sudo update config install

17. Refer to the exhibit.

Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to R2?

Option A

Option B

Option C

Option D

18. Refer to the exhibit.

An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2.

Which debug command is used to troubleshoot this issue?

debug ip flow

debug ip sla error

debug ip routing

debug ip packet

19. Refer to the exhibit.

An administrator that is connected to the console does not see debug messages when remote users log in.

Which action ensures that debug messages are displayed for remote logins?

Enter the transport input ssh configuration command.

Enter the terminal monitor exec command.

Enter the logging console debugging configuration command.

Enter the aaa new-model configuration command.

20. A network engineer is investigating a flapping (up/down) interface issue on a core switch that is synchronized to an NTP server. Log output currently does not show the time of the flap.

Which command allows the logging on the switch to show the time of the flap according to the clock on the device?

service timestamps log uptime

clock summer-time mst recurring 2 Sunday mar 2:00 1 Sunday nov 2:00

service timestamps log datetime localtime show-timezone

clock calendar-valid

Page 3 of 3

21. Refer to the exhibit.

What is the result if applying this configuration?

The router can form BGP neighborships with any other device.

The router can form BGP neighborships with any device that matched by the access list named ''BGP''

The router cannot form BGP neighborships with any other device

The router cannot form BGP neighborships with any device that is matched by the access list named ''BGP''

Welcome To Choose Required IT Certification Exams Online

Valid 300-410 Exam Questions [2022] – Great Preparation Tool For Passing Cisco CCNP Enterprise ENARSI Exam

Reading Cisco 300-410 Free Questions Is Recommended To Check 300-410 Exam Questions

Author